Sumoto

I sincerely apologise if my post caused offence. Based on my experiences over the years, it appears that very few individuals are willing to contribute or assist others. When such assistance does occur, it is undoubtedly invaluable, yet it seems challenging to connect with someone who possesses the necessary knowledge.

There must be someone available who can assist. Kindly or Is this forum as inactive as it appears?

My 2007 W639 Vito 111 CDI has begun experiencing fuel-related troubles. Exiting the conversation. The background is as follows: after performing repairs on an injector blow-by and the hold-down bolt threads, the car began to leak gasoline from its leak-off system. I suspected that I had been excessively forceful with the press-down clips on the plastic pipe fittings attached to the spigot pipes emerging from the side of the injector.I conducted a leak-off test and discovered that three of the injectors were defective, exhibiting excessive fuel leakage. Consequently, I acquired a whole set of replacement injectors, Honda copper washers, and new stretch hold-down bolts, and replaced them together with a brand new leak-off pipe system. after a run test drive i noticed it was leaking yet again but this time knowing full well the leak off was just a dribble and the leaking wouldnt start until at lease five mins of running ,i then purchased another pipe set believing it must of been a dud set i had previously got and fitted another new set ,another test run and another leak ensued so this time i thought it must be having trouble to leak back into the in-tank pumped supply line where it is plumbed into via an alloy y adapter ,having looked at it i considered it could either be a clogged filter (where the in tank pump brings the low pressure supply into) or maybe a locked up non return check valve which is in the new replaced leak off pipe so i checked the valve using air line and a peice of stiff wire all good replaced filter and test drive ,still leaking fuel out of the weakest point of the rubber leak off sections between the injectors , this tells me the pressure of the system where it is supposed to bleed into is far too high ? I assume that the return line to the tank may be obstructed. Could it be a defective pressure regulator valve in the common rail? Are there any technicians available to assist me in resolving this issue? I am perplexed; the vehicle starts and operates flawlessly. Could it be experiencing excessive pressure owing to a malfunctioning pressure control system? How does it control the pressure returning to the tank following its effective transit through the common rail? I am unable to locate anybody with the requisite experience and traditional diagnostic skills to identify this type of defect from the past.

https://www.realoem.com/bmw/enUS/select

Verify using your vehicle's VIN. Does the vendor not supply the VIN, or are there no local websites that offer the VIN along with the registration plate?

🥰

It is quite evident, indeed. Otherwise, there would be numerous shunts daily, as the majority of relatively new vehicles are equipped with Adaptive Cruise Control (ACC).

Presumably, you are referring to the scenario in which the Adaptive Cruise Control (ACC) detects a deceleration ahead and engages the brakes; otherwise, a rear-end collision with trailing vehicles would occur.

The dome-shaped plastic should simply detach. Ensure it is unobstructed and that the little arm behind the cover is not ajar.

A thorough cleaning may also be beneficial.

Allow your wife to operate the vehicle and get a superior option for yourself.

Did you acquire the vehicle with diminished power, or did you have the DPF and EGR systems reprogrammed, resulting in satisfactory performance thereafter?

Variations in tire tread depths exceeding a few millimeters between the front and rear tyres, as well as between tyres on the same axle, may lead to comparable troubles, since the transfer box is adversely affected by such discrepancies.

X drive versus conventional rear-wheel drive?

☺️

I was bewildered as I saw the continuous release of each subsequent model from 2010 forward, including the GT LMX Le Mans, among others.

Such is the consequence of cutting-edge technology: chain malfunctions, injector failures, and engine components of inferior durability in diesel engines.

Prestige +1

"I am uncertain about the specific services performed prior to purchasing the vehicle from Sytner." It is likely that insufficient effort was expended, since merchants often do the minimal necessary to sell old inventory. It may have had an oil change, oil filter replacement, and air filter replacement, but likely not much more. This inevitably brings up the contentious issue of the seven-year warranty. If it was sold with an active warranty and you paid a premium for this condition, ensure you possess an updated document of proper service under the Kia schedule. Kia is stringent on this matter and will reject any warranty claims for service issues not addressed promptly. They have also been known to advocate for any other things, even if they are not serviceable, despite the fact that non-serviceable objects are intended to be covered anyway. An instance of this might be an ECU or a door actuator, which is often anticipated to last for 7 years without maintenance.

My 2012 Venga with a 4-speed automatic gearbox now achieves 23 mpg or less during this season. The Sportage's greater weight renders sub-20 mpg unsurprising. I mostly engage in urban driving, with trips often under 2 miles, save for a monthly travel of 30 miles (15 miles each way). We typically drive around 3,000 miles annually, so it is not an issue for us. Due to disability concerns, I am unable to walk, and public transport is not a viable option in my area. I would be pleased to adopt a hybrid or electric vehicle, but it is financially unfeasible for me. I recommend examining common culprits such as sticky callipers or the handbrake, if you have not done so before.

My 2017 Chevrolet Orlando 1.8 LS is experiencing issues with the infotainment system; first, the volume control panel became unresponsive, and subsequently, the whole system intermittently powers on or remains off upon engine start. What may the issue be?

Fractured pipe it seems

you need to replace abs

I think they got broken after 100k miles

Diagrams may not always accurately depict the components, therefore use caution in placing excessive trust on them.